OS-1441 routing-setup service provides no useful log output (move met…

…hod from illumos-joyent)

overlay/generic/lib/svc/method/net-routing-setup

@@ -0,0 +1,214 @@
+#!/sbin/sh
+#
+# CDDL HEADER START
+#
+# The contents of this file are subject to the terms of the
+# Common Development and Distribution License (the "License").
+# You may not use this file except in compliance with the License.
+#
+# You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE
+# or http://www.opensolaris.org/os/licensing.
+# See the License for the specific language governing permissions
+# and limitations under the License.
+#
+# When distributing Covered Code, include this CDDL HEADER in each
+# file and include the License file at usr/src/OPENSOLARIS.LICENSE.
+# If applicable, add the following below this CDDL HEADER, with the
+# fields enclosed by brackets "[]" replaced with your own identifying
+# information: Portions Copyright [yyyy] [name of copyright owner]
+#
+# CDDL HEADER END
+#
+#
+# Copyright (c) 1999, 2010, Oracle and/or its affiliates. All rights reserved.
+
+# This script configures IP routing.
+
+. /lib/svc/share/smf_include.sh
+
+#
+# In a shared-IP zone we need this service to be up, but all of the work
+# it tries to do is irrelevant (and will actually lead to the service 
+# failing if we try to do it), so just bail out. 
+# In the global zone and exclusive-IP zones we proceed.
+#
+smf_configure_ip || exit $SMF_EXIT_OK
+
+#
+# If routing.conf file is in place, and has not already been read in
+# by previous invokation of routeadm, legacy configuration is upgraded
+# by this call to "routeadm -u".  This call is also needed when
+# a /var/svc/profile/upgrade file is found, as it may contain routeadm commands
+# which need to be applied.  Finally, routeadm starts in.ndpd by
+# enabling the ndp service (in.ndpd), which is required for IPv6 address
+# autoconfiguration. It would be nice if we could do this in
+# network/loopback, but since the SMF backend is read-only at that
+# point in boot, we cannot.
+#
+/sbin/routeadm -u
+
+#
+# Are we routing dynamically? routeadm(1M) reports this in the
+# "current" values of ipv4/6-routing - if either are true, we are running
+# routing daemons (or at least they are enabled to run).
+#
+dynamic_routing_test=`/sbin/routeadm -p | \
+nawk '/^ipv[46]-routing [.]*/ { print $2 }'  | /usr/bin/grep "current=enabled"`
+if [ -n "$dynamic_routing_test" ]; then
+	dynamic_routing="true"
+fi
+
+#
+# Configure default IPv4 routers using the local "/etc/defaultrouter"
+# configuration file.  The file can contain the hostnames or IP
+# addresses of one or more default routers.  If hostnames are used,
+# each hostname must also be listed in the local "/etc/hosts" file
+# because NIS is not running at the time that this script is
+# run.  Each router name or address is listed on a single line by
+# itself in the file.  Anything else on that line after the router's
+# name or address is ignored.  Lines that begin with "#" are
+# considered comments and ignored.
+#
+# The default routes listed in the "/etc/defaultrouter" file will
+# replace those added by the kernel during diskless booting.  An
+# empty "/etc/defaultrouter" file will cause the default route
+# added by the kernel to be deleted.
+#
+# Note that the default router file is ignored if we received routes
+# from a DHCP server.  Our policy is to always trust DHCP over local
+# administration.
+#
+smf_netstrategy
+
+if [ "$_INIT_NET_STRATEGY" = "dhcp" ] && \
+    [ -n "`/sbin/dhcpinfo Router`" ]; then
+	defrouters=`/sbin/dhcpinfo Router`
+elif [ -f /etc/defaultrouter ]; then
+	defrouters=`/usr/bin/grep -v \^\# /etc/defaultrouter | \
+	    /usr/bin/awk '{print $1}'`
+	if [ -n "$defrouters" ]; then
+		#
+		# We want the default router(s) listed in
+		# /etc/defaultrouter to replace the one added from the
+		# BOOTPARAMS WHOAMI response but we must avoid flushing
+		# the last route between the running system and its
+		# /usr file system.
+		#
+
+		# First, remember the original route.
+		shift $#
+		set -- `/usr/bin/netstat -rn -f inet | \
+		    /usr/bin/grep '^default'`
+		route_IP="$2"
+
+		#
+		# Next, add those from /etc/defaultrouter.  While doing
+		# this, if one of the routes we add is for the route
+		# previously added as a result of the BOOTPARAMS
+		# response, we will see a message of the form:
+		#       "add net default: gateway a.b.c.d: entry exists"
+		#
+		do_delete=yes
+		for router in $defrouters; do
+			route_added=`/usr/sbin/route -n add default \
+			    -gateway $router`
+			res=$?
+			set -- $route_added
+			[ $res -ne 0 -a "$5" = "$route_IP:" ] && do_delete=no
+		done
+
+		#
+		# Finally, delete the original default route unless it
+		# was also listed in the defaultrouter file.
+		#
+		if [ -n "$route_IP" -a $do_delete = yes ]; then
+			/usr/sbin/route -n delete default \
+			    -gateway $route_IP >/dev/null
+		fi
+	else
+		/usr/sbin/route -fn > /dev/null
+	fi
+else
+	defrouters=
+fi
+
+#
+# Use routeadm(1M) to configure forwarding and launch routing daemons
+# for IPv4 and IPv6 based on preset values.  These settings only apply
+# to the global zone.  For IPv4 dynamic routing, the system will default
+# to disabled if a default route was previously added via BOOTP, DHCP,
+# or the /etc/defaultrouter file.  routeadm also starts in.ndpd.
+#
+if [ "$dynamic_routing" != "true"  ] && [ -z "$defrouters" ]; then
+	#
+	# No default routes were setup by "route" command above.
+	# Check the kernel routing table for any other default
+	# routes.
+	#
+	/usr/bin/netstat -rn -f inet | \
+	    /usr/bin/grep default >/dev/null 2>&1 && defrouters=yes
+fi
+
+#
+# The routeadm/ipv4-routing-set property is true if the administrator
+# has run "routeadm -e/-d ipv4-routing".  If not, we revert to the
+# appropriate defaults.  We no longer run "routeadm -u" on every boot
+# however, as persistent daemon state is now controlled by SMF.
+#
+ipv4_routing_set=`/usr/bin/svcprop -p routeadm/ipv4-routing-set $SMF_FMRI`
+if [ -z "$defrouters" ]; then
+	#
+	# Set default value for ipv4-routing to enabled.  If routeadm -e/-d
+	# has not yet been run by the administrator, we apply this default.
+	# The -b option is project-private and informs routeadm not
+	# to treat the enable as administrator-driven.
+	#
+	/usr/sbin/svccfg -s $SMF_FMRI \
+	    setprop routeadm/default-ipv4-routing = true
+	if [ "$ipv4_routing_set" = "false" ]; then
+		/sbin/routeadm -b -e ipv4-routing -u
+	fi
+else
+	#
+	# Default router(s) have been found,  so ipv4-routing default value
+	# should be disabled.  If routaedm -e/d has not yet been run by
+	# the administrator, we apply this default.  The -b option is
+	# project-private and informs routeadm not to treat the disable as
+	# administrator-driven.
+	#
+	/usr/sbin/svccfg -s $SMF_FMRI \
+	    setprop routeadm/default-ipv4-routing = false
+	if [ "$ipv4_routing_set" = "false" ]; then
+		/sbin/routeadm -b -d ipv4-routing -u
+	fi
+fi
+
+#
+# See if static routes were created by install. If so, they were created
+# under /etc/svc/volatile. Copy them into their proper place.
+#
+if [ -f /etc/svc/volatile/etc/inet/static_routes ]; then
+	echo "Installing persistent routes"
+	if [ -f /etc/inet/static_routes ]; then
+		cat /etc/svc/volatile/etc/inet/static_routes | grep -v '^#' \
+		    >> /etc/inet/static_routes
+	else
+		cp /etc/svc/volatile/etc/inet/static_routes \
+		    /etc/inet/static_routes
+	fi
+	/usr/bin/rm /etc/svc/volatile/etc/inet/static_routes
+
+fi
+
+#
+# Read /etc/inet/static_routes and add each route.
+#
+if [ -f /etc/inet/static_routes ]; then
+	echo "Adding persistent routes:"
+	/usr/bin/egrep -v "^(#|$)" /etc/inet/static_routes | while read line; do
+		/usr/sbin/route add $line
+	done
+fi
+
+# Clear exit status.
+exit $SMF_EXIT_OK

overlay/generic/manifest

@@ -131,6 +131,7 @@ f lib/svc/method/identity-node 0555 root bin
 f lib/svc/method/manifest-import 0555 root bin
 f lib/svc/method/mdata-fetch 0555 root bin
 f lib/svc/method/net-physical 0555 root sys
+f lib/svc/method/net-routing-setup 0555 root bin
 f lib/svc/method/console-login 0555 root bin
 f lib/svc/method/sysidtool-net 0555 root bin
 f lib/svc/method/sysidtool-system 0555 root bin