OH4A2A1-1 Landing Gear Panel legend and light plate do not cover back plate cutout to PCB at bottom center

[Arribe]

Summary:

The light and legend plates do not extend over a backplate cutout on the landing gear panel. LED backlighing for the DN legend will likely blead out the hole.

Expected Results/How It Should Work:

The cut out for the LED/Resistor should be covered by the light and legend plate.

Actual Results/How It Does Work:

There is a small gap that doesn't cover the backplate cutout fully.

Screenshots:

More Information

Add an "X" in the square brackets to check the applicable checkboxs.

Category:

Check one or more items.

• MCAD (SolidWorks)
• ECAD (PCB Design or other electrical hardware)
• Software - Sketch
• Software - DCS-BIOS
• Software - Library

Type:

Check one item.

• Bug
• Feature Enhancement
• Maintenance
• Question
• Documentation

Applicable End Item:

Check one item.

• Top Level Assembly
• Lower Instrument Panel (LIP)
• Main Instrument Panel (MIP)
• Left Console
• Right Console
• Seat
• Center Tub
• Flight Stick
• Throttle
• General Software

Associated Filename(s):

Insert assembly or part file names here, i.e. 123456.sldasm, etc.

[Arribe]

I have this gap in the panel I built, and have seen photos on discord from other builders that also have this gap.

[jrsteensen]

As a workaround, pot it with black RTV or similar.

We will get this in after B1 - trying very hard to not change any PCBs for relatively minor things until there is something that drives us to do more than one thing to a PCB.