Netmiko enters to conf t on Cisco ASA for show command

[pavelchjen]

New to netmiko. In short, noticed that my script which was performed 'show license' command in exec mode (not conf t) actually causing config change on ASAv -- and debugging show its enters to conf t for some reason.
While interested command output was just one bellow. Is there a way to avoid config change and entering into 'conf t'?
code:
CiscoASA = {
'device_type': 'cisco_asa',
'ip': ip,
'username': username,
'password': password,
'port': 22,
'auth_timeout': 10,
'timeout': 10,
'verbose': False,
}
fail=False
try:
net_connect = ConnectHandler(**CiscoASA)
#net_connect.ansi_escape_codes = True
except (AuthenticationException):
print (hostname,",Authentication failure: " + ip)
fail=True
pass

     if not fail:
        output = net_connect.send_command("show license status",read_timeout=10)

[ktbyers]

You can pass the argument auto_allow_change = False.

Note, in general long commands and Netmiko will break (if the terminal width is not increased). Long commands being commands where the prompt + command is longer than about 80 characters.