You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
like i mentioned in the past, here are one of my suggestions for better Workflow:
Would be good to have the ability to Add more then one view in the "Draw" submenu.
Sometimes i need not only a Isometric-View of a part, also a View from right, left or some other angle.
Of course, it is possible now, but when exporting/printing, it will generate one seperate PDF/Layout-File for each view-angle. I would like to suggest, do consider a option to add a second or third or x additional view/page and get it exported/printed combined in one file.
I hope my explenaitions are good to understand.
Thank you
The text was updated successfully, but these errors were encountered:
I understand you too..
Just wanted to post my suggestions, without any expectations :)
If I never mention it, I definitely don't get it. At least there is a chance..
Hi,
like i mentioned in the past, here are one of my suggestions for better Workflow:
Would be good to have the ability to Add more then one view in the "Draw" submenu.
Sometimes i need not only a Isometric-View of a part, also a View from right, left or some other angle.
Of course, it is possible now, but when exporting/printing, it will generate one seperate PDF/Layout-File for each view-angle. I would like to suggest, do consider a option to add a second or third or x additional view/page and get it exported/printed combined in one file.
I hope my explenaitions are good to understand.
Thank you
The text was updated successfully, but these errors were encountered: