mapping.go

package service

var smodeMapping = map[int]string{
	0x2001: "POWER OFF",
	0x2002: "UNIT OFF",
	0x2003: "G-SET OFF",
	0x2004: "Battery OFF",
	0x2005: "SPTI START(MODEM)",
	0x2006: "FPTI START(MODEM)",
	0xA001: "POWER ON",
	0xA002: "UNIT ON",
	0xA003: "G-SET ON",
	0xA004: "Battery ON",
	0xA005: "SPTI START(PANEL)",
	0xA006: "FPTI START(PANEL)",
	0xA007: "M.CHECK START(PANEL)",
	0xA008: "MANUAL DEFROST(PANEL)",
	0xA009: "Change Container ID",
	0xB010: "Defrost finish",
	0xB011: "Defrost start",
	0xB040: "Finish PTI with NG result",
	0xB041: "Finish PTI with OK result",
	0xB100: "Set DHU to OFF by PANEL",
	0xB101: "Set DHU to ON by PANEL",
	0xB102: "Set DHU to OFF by MODEM",
	0xB103: "Set DHU to ON by MODEM",
}

var faultCodeMapping = map[byte]string{
	0x00: "No alarm",
	0x01: "Power up",
	0x02: "Sensor failure",
	0x03: "Hign evaporator temperature",
	0x04: "High head",
	0x05: "Evaporator fan  motor",
	0x06: "Condenser fan motor",
	0x07: "Comressor",
	0x08: "Defrost termin on time limit",
	0x09: "Temperature out of range",
	0xa:  "Low pressure",
	0xb:  "Low compressor oil pressure",
	0xc:  "Pump down termin on time limit",
	0xd:  "Charge",
	0xe:  "Microprocessor faulty",
	0xf:  "Alarm reset",
	0x10: "Fuse (control)",
	0x20: "F101",
	0x21: "F109",
	0x22: "F111",
	0x23: "F301",
	0x24: "F401",
	0x25: "F403",
	0x26: "F603",
	0x27: "F701",
	0x28: "F705",
	0x29: "F803",
	0x2a: "Unused",
	0x2b: "Unused",
	0x2c: "Unused",
	0x2d: "Unused",
	0x2e: "E406",
	0x2f: "E407",

	0x30: "E101",
	0x31: "E103",
	0x32: "E105",
	0x33: "E107",
	0x34: "E109",
	0x35: "E201",
	0x36: "E203",
	0x37: "E205",
	0x38: "E207",
	0x39: "E303",
	0x3a: "E305",
	0x3b: "E307",
	0x3c: "E311",
	0x3d: "E313",
	0x3e: "E315",
	0x3f: "E401",

	0x40: "E403",
	0x41: "E405",
	0x42: "E409",
	0x43: "E411",
	0x44: "E413",
	0x45: "E415",
	0x46: "E417",
	0x47: "E419",
	0x48: "E421",
	0x49: "E423",
	0x4a: "E425",
	0x4b: "E427",
	0x4c: "E429",
	0x4d: "E431",
	0x4e: "E603",
	0x4f: "E607",

	0x50: "E707",
	0x51: "E801",
	0x52: "E805",
	0x53: "E807",
	0x54: "E402",
	0x55: "E404",
	0x56: "E901",
	0x57: "E433",
	0x58: "Unused",
	0x59: "Unused",
	0x5a: "Unused",
	0x5b: "Unused",
	0x5c: "Unused",
	0x5d: "F405",
	0x5e: "F407",
	0x5f: "F409",

	0x60: "F528",
	0x61: "F52E",
	0x62: "F52F",
	0x63: "F536",
	0x64: "F538",
	0x65: "F539",
	0x66: "F53A",
	0x67: "F53B",
	0x68: "F53C",
	0x69: "F53D",
	0x6a: "F703",
	0x6b: "F707",
	0x6c: "F809",
	0x6d: "E115",
	0x6e: "E117",
	0x6f: "E435",

	0x70: "E437",
	0x71: "E523",
	0x72: "E524",
	0x73: "E525",
	0x74: "E526",
	0x75: "E528",
	0x76: "E52C",
	0x77: "E52D",
	0x78: "E52E",
	0x79: "E52F",
	0x7a: "E531",
	0x7b: "E532",
	0x7c: "E533",
	0x7d: "E536",
	0x7e: "E53C",
	0x7f: "E53D",

	0x80: "E542",
	0x81: "E5FF",
	0x82: "E701",
	0x83: "E809",
	0x84: "E903",
	0x85: "E439",
	0x86: "E419",
	0x87: "E202",
	0x88: "E304",
	0x89: "Unused",
}

var opModeMapping = map[byte]string{
	0x0: "Defrost",
	0x1: "Full Cool",
	0x2: "Modulation",
	0x3: "Thermo Off",
	0x4: "Remote Unit Off",
	0x5: "Unit Off",
	0x6: "Emergency Stop (Automatically reset)",
	0x7: "Emergency Shut Down",
	0x8: "Manual check",
	0x9: "Short PTI",
	0xa: "Full PTI",
	0xb: "Emergency Stop in PTI",
	0xc: "Stop in PTI",
	0xd: "Heating",
	0xe: "Non Control",
	0xf: "Electric Power Shut Off",
}