Manual Pick and Place Automatic Tape Feeder

This code controll the ON and OFF of the Automatic Tape Feeder (ATF) on a manual Pick and Place Machine.

License

This project is licensed under the Attribution-NonCommercial-ShareAlike CC BY-NC-SA 4.0 license. The full legal text of the license may be found in the LICENSE.txt file in this repository. For more information about this license, please visit the Creative Commons Foundation (https://creativecommons.org/licenses/by-nc-sa/4.0/).

Features

• Soft-shutdown Pi from power switch

• Reset button functionality

• Easy Temperature Control

• 2 wire fan control

• One-line script installation

---

ATF Control Board

Front Side:

Back Side:

---

Software Installation

NOTE: This assumes that you have already connected the ATF board and the POWER button is pressed;

This instructions are a step-by-step guide to install the necessary software for the Automatic Tape Feeder Module.

---

Open a SSH terminal session and type the one-line installation command below:

$ wget -O - "https://github.com/mafe72/Manual-Pick-and-Place-Automatic-Tape-Feeder/raw/master/install.sh" | sudo bash

---

The script will automatically install pertinent files and configure your Raspberry Pi to enable the Automatic Tape Feeder Module. Installation will automatically reboot once all processes are completed.

After rebooting, the Automatic Tape Feeder Module is now fully functional.

Software Uninstall

This instructions are a step-by-step guide to uninstall the software for the Automatic Tape Feeder Module.

---

Open a SSH terminal session and type the one-line uninstall command below:

$ wget -O - "https://github.com/mafe72/Manual-Pick-and-Place-Automatic-Tape-Feeder/raw/master/uninstall.sh" | sudo bash

The script will automatically uninstall all configuration files from your Raspberry Pi to disable the Automatic Tape Feeder Module. The uninstall script will automatically shutdown once all processes are completed.

After shutdown, the Automatic Tape Feeder Module will be fully deactivated.

---

Basic Usage

• POWER ON

    While powered off
    	Press (LATCH) POWER button
    	LED will turn ON
    	Wait for Raspberry Pi to boot		
  

• POWER OFF

    While powered on
    	Press (Unlatch) POWER button
    	LED will turn OFF
    	Wait for Raspberry Pi to shutdown	
  

• RESET

    Press the Reset button
    LED will BLINK
    Wait for Raspberry Pi to reboot
  

• FAN CONTROL

    FAN will turn ON if CPU temp exceeded 55C and turn OFF when CPU temp is under 40C
  

---

Troubleshooting