You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Just noticed this bug and I thought I might let you know. When you open up a gcode file with the feedrate set to 100 and simplify the file the feedrate setting gets deleted and grbl defaults to a very slow feedrate, which forces you to pause the job, enter the feedrate through the manual control box, and continue the job. I just tested it with a feedrate set to 101 and it does not get deleted by the simplifier.
The text was updated successfully, but these errors were encountered:
Thanks for pointing this out!
The problem was that the default feed rate was set to 100mm/min, so it wouldn't detect a change in feedrate. This also meant that a feed rate of 100mm/min was assumed when no feed was specified (which does not comply with the gcode standard)
Just noticed this bug and I thought I might let you know. When you open up a gcode file with the feedrate set to 100 and simplify the file the feedrate setting gets deleted and grbl defaults to a very slow feedrate, which forces you to pause the job, enter the feedrate through the manual control box, and continue the job. I just tested it with a feedrate set to 101 and it does not get deleted by the simplifier.
The text was updated successfully, but these errors were encountered: