v0.10 does not go to full speed

[KingKone]

Hi, first of all, thx for your great work!

Just tested v0.10 and the reported RPM stops around 3700-4000, it is spinning to slow by the sound of it.

After I have noticed that, I checked with v0.9 and reported RPM is around 32000 (empty 5S 1750KV), sounds right again.

ESC Config is on defaults.

• Bluejay version: 0.10 (24 & 48 kHz)
• ESC variant: C-H-40 (Mamba F405 MK2 Stack)
• Bidirectional DShot: On
• FC firmware: BF 4.2

If you need me to test something, I am up for testing.

[mathiasvr]

Hi, thanks for the report!

That sounds strange, having the rpm protection setting very low could cause this, are you sure it was at default of 9x?
If that's the case I will have to examine the C layout more closely.

[mathiasvr]

@KingKone Can you confirm this happens with the default settings?

[koen352003]

I'm using the same mamba f405 mk2 stack, and for me 0.12 (test1) has been working and flying perfectly fine on defaults.

[mathiasvr]

@koen352003 Thank you for the report!

I don't know what could have caused this issue other than the mentioned setting, so it's strange using v0.9 would work - maybe the settings were not the same for some reason.
Anyway, I think we can close this for now then.

[ericogr]

I'm using the same mamba f405 mk2 stack, and for me 0.12 (test1) has been working and flying perfectly fine on defaults.

Same here. Today, experimented 4x1 Mamba F40HV ESC with C-H-40, 0.12, 48 kHz, Bluejay (BETA) with 6S battery with success!
Params:

startups: 1010/1028
timing: mediumHigh
demag: high
rampup: 5x