Replies: 3 comments
-
Just something to try... flash the GENERIC_1M firmware and see if that works. |
Beta Was this translation helpful? Give feedback.
-
You can see the common troubleshooting guideline and a thread from the old micropython forum. I am sharing the links. You can check and see if they help. By the way, if you ever consider making a self balancing robot using ESP32, you can follow this design. https://www.pcbway.com/project/shareproject/Self_Balancing_Robot_Using_ESP32_1171d9cb.html |
Beta Was this translation helpful? Give feedback.
-
Finally I managed to flash ESP8266_GENERIC-20230426-v1.20.0.bin and that one works after having erase the ESP8266 flash. |
Beta Was this translation helpful? Give feedback.
-
This is what I see:
load 0x40100000, len 30720, room 16
tail 0
chksum 0xba
load 0x3ffe8000, len 996, room 8
tail 12
chksum 0x2c
ho 0 tail 12 room 4
load 0x3ffe83f0, len 1080, room 12
tail 12
chksum 0x43
csum 0x43
rf_cal[0] !=0x05,is 0xFF
ets Jan 8 2013,rst cause:2, boot mode:(3,6)
Flashing seems to work without problems. I tried with firmware I compiled myself but also with ESP8266_GENERIC-20230426-v1.20.0.bin. Always the same story.
Any idea what is going wrong? I did run micropython on the board before (long time ago)
Beta Was this translation helpful? Give feedback.
All reactions