32 bit ASK demodulation support

[ozkangoksu]

Hello.

I'm trying to implement a 32 bit remote receiver and looking a way to use your project.

My 32 bit remote pattern is:
One frame code structure of this project is (20bit address+5bit key value+3bit PID code+4bit check code+syn code)
The code type of this project has 4 bytes of data in one frame, CODE1, CODE2, CODE3, CODE4, which are sent in order from high to low. The first 20BIT is the remote control address value,
21BIT-25BIT is the key value, 26-28bit is the PID code, and 29-32BIT is the check code.
Each BIT pattern "1" code: 720us high level + 240us low level "0" code: 240us high level + 720us low level

So the question is what should I do to reach that goal?

[nimaltd]

hello. All bit change store in ask struct's buffer. you have to change ask_available() function to detect your algorithm

[ozkangoksu]

Ok that's nice to hear.
I'm newbie with stm32 and RF communication. May I ask some hints about my remote and algorithm if you don't mind?

This is the datasheet of my remote:
433 MHz Remote Control.pdf

This is Remote's RF structure:

I tried rc-switch project with an arduino and rc-switch can decode my remote with their protocol 1 as below:

04:10:57.252 -> Decimal: 3899580674 (32Bit) Binary: 11101000011011101110000100000010 Tri-State: not applicable PulseLength: 252 microseconds Protocol: 1
04:10:57.389 -> Raw data: 6116,732,240,732,248,728,244,236,736,732,248,236,732,244,732,244,740,240,728,732,244,736,240,244,732,728,244,728,248,52,52,104,40,88,1052,1684,16,1160,32,1680,24,60,268,24,36,36,2992,44,3496,564,68,48,88,452,208,2680,40,40,1328,96,200,68,620,160,52,

If you don't mind, can you pinpoint the important and hard to understand changes and values?

[ozkangoksu]

For 32 bit support I've changed Byte_len and it works now.
#define ASK_MIN_BYTE_LEN 3 // byte
#define ASK_MAX_BYTE_LEN 3 // byte