You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
For plastic cases I assume it doesn't matter, but I used the top layer file to get steel plates cut. Since the plates were only finished on one side they weren't reversible and the screw holes are going to be in the wrong spot for one half of the keyboard.
The text was updated successfully, but these errors were encountered:
Ah yes, I had the same issue with the Nyquist when I did the first run of stainless steel plates, didn't realize the back side would be rough and unsuitable for flipping. I'll get some revised files up this week.
For plastic cases I assume it doesn't matter, but I used the top layer file to get steel plates cut. Since the plates were only finished on one side they weren't reversible and the screw holes are going to be in the wrong spot for one half of the keyboard.
The text was updated successfully, but these errors were encountered: