You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
{{ message }}
This repository has been archived by the owner on May 17, 2021. It is now read-only.
I'm running openhab 1.4.0 mainly for binding to my KNX-environment.
I've created a few switches that binds to their respective KNX GA and connect to the KNX bus in router mode. The communication with the KNX bus seem to work fine and in the event log I can see that OH receives status updates from the bus.
The problem is that the GUI in habdroid is not beeing updated. If a command a switch to "off" via the habdroid GUI, the switch goes off and OH (in the event log) receives status update on this. But the lightbulb in habroid is still showing the switch beein on. If I navigate around a bit in habroid and thus updating the page the lightbulb reflects the correct state.
In the webgui this seems to work much better.
Is this a habroid, configuration or oh-problem?
The text was updated successfully, but these errors were encountered:
I'm running openhab 1.4.0 mainly for binding to my KNX-environment.
I've created a few switches that binds to their respective KNX GA and connect to the KNX bus in router mode. The communication with the KNX bus seem to work fine and in the event log I can see that OH receives status updates from the bus.
The problem is that the GUI in habdroid is not beeing updated. If a command a switch to "off" via the habdroid GUI, the switch goes off and OH (in the event log) receives status update on this. But the lightbulb in habroid is still showing the switch beein on. If I navigate around a bit in habroid and thus updating the page the lightbulb reflects the correct state.
In the webgui this seems to work much better.
Is this a habroid, configuration or oh-problem?
The text was updated successfully, but these errors were encountered: