You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I have found this polling sequence in several forum debug logs and am not sure if this is how it is supposed to work. Could you clarify (if you get a chance)
Get command in 32 ms (right after Set command is finished)
Command Poll at 1500 ms polls every channel (Basically a "refresh")
No real harm except a lot of traffic. Also I thought the command poll delay was to allow time for a slow device to get to the SET state.
(Note the actual problem for the OP in the forum was that the SET command was not 'sticking', but my question is on the GET and command poll of all the channels)
The text was updated successfully, but these errors were encountered:
I have found this polling sequence in several forum debug logs and am not sure if this is how it is supposed to work. Could you clarify (if you get a chance)
thermostat-set-setpoint-fail.log
what is happening
No real harm except a lot of traffic. Also I thought the command poll delay was to allow time for a slow device to get to the SET state.
(Note the actual problem for the OP in the forum was that the SET command was not 'sticking', but my question is on the GET and command poll of all the channels)
The text was updated successfully, but these errors were encountered: