You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
On r1 builds, nodes will frequently not issue DHCP leases when connected over ethernet. When this happens, nodes will be stuck in a loop of disconnected/reconnecting until I manually assign an ip address to eth0.
This happens both before running the setup wizard and after, but doesn't happen consistently. Hardware used was ubiquiti picostation.
When you're connecting after setup has been completed, it's always the case that the node AP will be accessible and give out DHCP leases. Rebooting the node fixes the issue.
This is fairly likely to be a race condition.
The text was updated successfully, but these errors were encountered:
On r1 builds, nodes will frequently not issue DHCP leases when connected over ethernet. When this happens, nodes will be stuck in a loop of disconnected/reconnecting until I manually assign an ip address to
eth0
.This happens both before running the setup wizard and after, but doesn't happen consistently. Hardware used was ubiquiti picostation.
When you're connecting after setup has been completed, it's always the case that the node AP will be accessible and give out DHCP leases. Rebooting the node fixes the issue.
This is fairly likely to be a race condition.
The text was updated successfully, but these errors were encountered: