You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I got the "HI.CONCENTRATION" ino to work and have good readings. I'm trying to get this sensor and a MHT11 temp/humidity sensor to operate on the same sketch and output T / H / O3 on the same display. Baud rate on MQ131 sketch is 115200, on DHT11, the baud rate is 9600. Can I either change the MQ131 sketch to 9600 or operate two baud rates on separate serial ports? If I do that, I don't think I can monitor both. Thanks!
Hi @chazbevo,
It is not a question related to the driver. It is a programming question.
I suggest you post it on the Arduino forum or Stackoverflow forum.
KR
I got the "HI.CONCENTRATION" ino to work and have good readings. I'm trying to get this sensor and a MHT11 temp/humidity sensor to operate on the same sketch and output T / H / O3 on the same display. Baud rate on MQ131 sketch is 115200, on DHT11, the baud rate is 9600. Can I either change the MQ131 sketch to 9600 or operate two baud rates on separate serial ports? If I do that, I don't think I can monitor both. Thanks!
Originally posted by @chazbevo in #17 (comment)
The text was updated successfully, but these errors were encountered: