is this built can work on macOS Mojave 10.14.6?

[jiaoxj86]

I completely followed the guid downloaded Mojave 10.14.6 and make a install usb disk.
But when I finished installation and selected Boot macOS from ... ,after a long time waiting,it just stuck at kextd stall[n],(240s):'appleACPICPU'.
Is that mean this built only work on macOS Mojave 10.14.5?

[22dm]

Same problem, waited for nearly 20 mins (the kextd stall[n],(240s):'appleACPICPU' appeared 3 times), it rebooted, then I met the #19, try to press space in the clover and select Boot macOS with injected kexts.

[ghost]

I followed the guide meticulously, and was successful. The only thing I did slightly differently was the first thing I did when booting into the USB was to go to Terminal (before Disk Utility) and zero out the SSD for a few thousand blocks (dd if=/dev/zero of=/dev/diskx bs=1m), Ctrl-C out, quit terminal, and then back to Disk Utility for a fresh erase/partition.

[adriavidal]

Instalation with the guide was ok, but after clover install to hd, efi replace when booting ( sloow), finally the NUC reboot. (i7-8705G 16+16 Gb `RAM) Mojave 10.14.6

Bios defaul + changes done

booting with these EFI

full.default.efi.zip

Could someone provide a succesful EFI i could try?

edited:

booting with injected kexts, and moving to PolarisMetalFix system boots fine and fast.

thanks

[adriavidal]

After 10.14.6 suplemental upgrade get a new kernel panic.

any suggestion ?

[osy]

Add this patch to disable the extra log entries otherwise I cannot see the error message. https://github.com/RehabMan/Intel-NUC-DSDT-Patch/blob/master/config_nuc8_bc.plist#L261

[ghost]

After 10.14.6 suplemental upgrade get a new kernel panic.

Similar issue...I got to the clover screen, but it didn’t count down and auto boot, and it fails to recognize a usb keyboard.

I’ll mess with it some more tonight.

[adriavidal]

Add this patch to disable the extra log entries otherwise I cannot see the error message. https://github.com/RehabMan/Intel-NUC-DSDT-Patch/blob/master/config_nuc8_bc.plist#L261

seems to be CPU related, checked at clover BIOS the TRUST to yes as someone suggested, without succes

[adriavidal]

Add this patch to disable the extra log entries otherwise I cannot see the error message. https://github.com/RehabMan/Intel-NUC-DSDT-Patch/blob/master/config_nuc8_bc.plist#L261

seems to be CPU related, checked at clover BIOS the TRUST to yes as someone suggested, without succes

forget about it.
done a clean install, upgrade with combo and all is up & running.
thanks for the great work!!