-
Notifications
You must be signed in to change notification settings - Fork 1
/
WBB and kinect installation.txt
39 lines (30 loc) · 1.98 KB
/
WBB and kinect installation.txt
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
Please note that the software should be run directly from the installed folder since shortcut will not work
On the very first time, please make sure WiiLab and Kinect are properly installed
1-WiiLab Navigate to TEKTRIS_FOLDER/WiilAB
Run as an administrator (right-click/Run as an administrator) the "InstallWiiLab" script
If you run it directly from the script (instead of the binary version)
2-Kinect Plug-in the Kinect to USB port (wait until Windows finished to properly install the drivers)
Launch matlab
Run the next command
imaq.internal.Utility.supportPackageInstaller
On the left pane, select "Kinect for Windows Sensor"
Check the install's action on the right pane
Click next and follow the instructions
Please note that this software has only been tested with the Kinect 1 for Windows
If you run it from the binary (instead of the script
2-Kinect Install the Windows Kinect SDK available on Microsoft.com
IMPORTANT NOTE : next section has to be done after installation and after each shut down of the computer!
1-Wii Balance Board Open Windows' bluetooth devices panel
Delete any Nintedo device
Click add a new device
Press the synchro button on the Wii balance Board and keep it pressed throughout the installation* (red button inside the battery compartment)
Add the WBB device (Should look something like : "Nintendo RVL-WBC-01")
Choose the option to couple without a code or do not enter a code if prompted.
* Please note problems were experienced when not pushing the synchro button throughout the installation process.
Finally, run TEKTRIS_FOLDER/Tektris.m
To use the Wii Balance board
If using the Kinect sensor: place the board in front of it, at a 3m distance.
The word Wii should be in front of the user while standing on the board.
Calibration
Calibrate with the user at the begining of every session.
Follow the instructions on the screen: separate calibrations are required for the Wii balance board and for the Kinect.