You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
{{ message }}
This repository has been archived by the owner on Oct 13, 2022. It is now read-only.
Thank you for your work.
I successfully flashed wr703n, but with mr3420 v2.1 I have a problem. I do not push the reset, but always get:
Button was pressed for 10 sec...
Starting U-Boot netconsole
If I push reset on 3-5second nothing happens and after 10 seconds I have the same:
Button was pressed for 10 sec...
Starting U-Boot netconsole
Help please
The text was updated successfully, but these errors were encountered:
I don't have any MR3420 v2.x at this moment, but I will test it on WR841N v8.x and confirm that it's working (button functionality). WR841N v8.x uses the same hardware platform.
In worst case, you might have small short somewhere on your PCB, so that the GPIO17, used with reset button is always in active state. I have seen some other TP-Link models with that kind of problem.
Thank you for your work.
I successfully flashed wr703n, but with mr3420 v2.1 I have a problem. I do not push the reset, but always get:
Button was pressed for 10 sec...
Starting U-Boot netconsole
If I push reset on 3-5second nothing happens and after 10 seconds I have the same:
Button was pressed for 10 sec...
Starting U-Boot netconsole
Help please
The text was updated successfully, but these errors were encountered: