-
Notifications
You must be signed in to change notification settings - Fork 25
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
calo improvviso emissione fascio laser/pwm #102
Comments
Sorry to hear of the problem. Was there any message in the console when this happened? Could you still talk to grblHAL? (for example, send $$, get settings listed back?) Did you check the temperature of the electronics (Laser PSU mostly)? Make sure all your wiring and connections are good (intermittent connections can be trouble). What happens when you run the same job? If you get the problem again, check the LED on the Teensy 4.1. It is connected to PWM so will give you an indication of what grblHAL is outputting. Full bright - 100%, off - 0%, half bright - 50%. If it is off and Lightburn thinks it is on, then it is a grblHAL or T41U5XBB problem. If the LED is lit up but laser output is low then it is likely a problem with the laser, wiring or power supply. |
potevo parlare con grblhal, ho premuto stop su LB e ho eseguito l'homing. Niente è stato spento per raffreddarsi, dopo homing ho ripreso subito il lavoro |
OK, keep an eye on the Teensy LED if this happens again. |
ok, l'amperometro segnava, poco ma segnava, era come un'uscita settata al 20% ma eseguita al 1%. |
Salve, oggi stavo facendo una lavorazione su 3 livelli colore di lightburn, 1° livello foto modalità stucki, 2° riempimento di contorni e 3° taglio. Il problema si presenta dopo aver fatto perfettamente la foto, finisce la foto e passa al riempimento. Effettua si e no 20 linee di riempimento, impostato a 8000mm/min 20% 0.08 linee per millimetro, e all'improvviso mi accorgo che il laser si muove ma non ho emissione di fascio, l'amperometro da 0-30mA segna forse 2 e nel plexiglass si vede che il riempimento non c'è. Blocco tutto, rifaccio l'homing, seleziono soltanto 2° livello-riempimento e 3° livello-taglio e porto a termine il lavoro. Utilizzo teensy4.1+T41U5XBB. Non riesco a capire da cosa può dipendere tutto questo, la macchina funzionava prima e funzionava anche dopo, è come se il controller abbassa, ma non azzera, l'uscita pwm, dopo l'homing (senza toccare altro, tipo spegnere e rieccendere ecc...) tutto funziona come prima. Anche la temperatura era nel range valido e segnava 13.4 °C
The text was updated successfully, but these errors were encountered: