You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Originally posted by pierrerdurand February 23, 2022
Have a new grblHal breakout board v2.07 fully built.
Have uploaded the 'grblHAL_T41 3X qei.hex' with the Teensy loader.
Installed ioSender 2.0.36 on windows 11
Have one DM556 stepper controller connected to the X axis connections with a bi-polar CUI stepper attached to the stepper controller.
Nothing else is connected to the board other than the USB power from the windows PC.
When I launch ioSender 2.0.36 (with the DM556 attached or not attached) I get the ALARM:10 error: "E-Stop active! - clear before continuing..."
After acknowledging the message, I get E-Stop still active, exit?" message and am unable to to any other actions.
What I am doing wrong?
The text was updated successfully, but these errors were encountered:
Discussed in #51
Originally posted by pierrerdurand February 23, 2022
Have a new grblHal breakout board v2.07 fully built.
Have uploaded the 'grblHAL_T41 3X qei.hex' with the Teensy loader.
Installed ioSender 2.0.36 on windows 11
Have one DM556 stepper controller connected to the X axis connections with a bi-polar CUI stepper attached to the stepper controller.
Nothing else is connected to the board other than the USB power from the windows PC.
When I launch ioSender 2.0.36 (with the DM556 attached or not attached) I get the ALARM:10 error: "E-Stop active! - clear before continuing..."
After acknowledging the message, I get E-Stop still active, exit?" message and am unable to to any other actions.
What I am doing wrong?
The text was updated successfully, but these errors were encountered: