You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hi, it would be very useful to control a gpio pin and not just the LED output when the controller is enabled. This will make it very simple for the pico-cs to be used with many H-bridge modules with an enable input as the booster. Without this some DCC locos when attached to DC power (no dcc signal) assume they're in DC mode and start to accelerate.
Again, this is great work! Thanks, Max.
The text was updated successfully, but these errors were encountered:
Hi, it would be very useful to control a gpio pin and not just the LED output when the controller is enabled. This will make it very simple for the pico-cs to be used with many H-bridge modules with an enable input as the booster. Without this some DCC locos when attached to DC power (no dcc signal) assume they're in DC mode and start to accelerate.
Again, this is great work! Thanks, Max.
The text was updated successfully, but these errors were encountered: