You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Line 22 leaves the printer in absolute mode.
Line 38 the touches the nozzle to the z probe,
Line 39 then G0 Z2 F1500 which is intended to move the nozzle up, but if the z probe offset is more than 2mm it actually moves DOWN smashing into the Z probe.
I suggest adding a G91 just before line 39 as a fix.
The text was updated successfully, but these errors were encountered:
Looking at configuration/homing.cfg:
Line 22 leaves the printer in absolute mode.
Line 38 the touches the nozzle to the z probe,
Line 39 then G0 Z2 F1500 which is intended to move the nozzle up, but if the z probe offset is more than 2mm it actually moves DOWN smashing into the Z probe.
I suggest adding a G91 just before line 39 as a fix.
The text was updated successfully, but these errors were encountered: