You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
It seems that the Z calibration value is ignored when printing with disconnected MMU2 unit (MK2.5, firmware 3.4.2).
On left is the piece from the end of 1st layer calibration, It can't be sqeezed any further down. On the right side is whatever other object I try to print. It barely holds to the bed because Z starts to high. It seems that Z is not adjusted bz the value set during the 1st layer calibration (0.850).
The text was updated successfully, but these errors were encountered:
GitHub issues are not for general support. They are best used for focused, clearly defined software issues. I recommend you connect with Prusa using their Chat service available on the shop page at https://shop.prusa3d.com/ You'll need to be logged in for the Chat tool to appear. I can also recommend the Prusa forums at: https://shop.prusa3d.com/forum/index.php
It seems that the Z calibration value is ignored when printing with disconnected MMU2 unit (MK2.5, firmware 3.4.2).
On left is the piece from the end of 1st layer calibration, It can't be sqeezed any further down. On the right side is whatever other object I try to print. It barely holds to the bed because Z starts to high. It seems that Z is not adjusted bz the value set during the 1st layer calibration (0.850).
The text was updated successfully, but these errors were encountered: