You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
3D printer brand / version + firmware version (if known)
MK3S
Behavior
I have created two cylindric modifiers to increase the infill in specific reagions of a gear wheal.
I wanted to have the inner modifier ( first in list ) to have 100% infill. The second cylinder
sets the infill to 15%.
This should result in a inner and outer reagion with 100% infill.
Problem is that the infill of the inner cylinder is lost when set to 100%. When changed to 90% it is working
Similar to #3272
The object volumes were not processed in the order they are displayed at the side panel. That will change with PrusaSlicer 2.4.0-alpha, the last object will win.
Version
2.3
Operating system type + version
Win 2010 for WS 2004
3D printer brand / version + firmware version (if known)
MK3S
Behavior
I have created two cylindric modifiers to increase the infill in specific reagions of a gear wheal.
I wanted to have the inner modifier ( first in list ) to have 100% infill. The second cylinder
sets the infill to 15%.
This should result in a inner and outer reagion with 100% infill.
Problem is that the infill of the inner cylinder is lost when set to 100%. When changed to 90% it is working
Project File (.3MF) where problem occurs
ZahnscheibeWelle40.zip
The text was updated successfully, but these errors were encountered: