Bridging infill fails on unsupported edges

[Automatica-Mat]

Version

All Versions

Version 2.4.0-alpha-win64

Operating system type + version

Window x64

Artillery Sidewinder X1

Bridging infill needs a perimeter made first to support edges. On low-density infill new horizontal layers require a perimeter to support the bridging infill.
The current result is where the bridging infill layer lines end where they do not connect to the other structures the sag which can not be recovered. The surface finish is then affected.

The sections circled in yellow are not connected to anything and fail. If a perimeter was first established the would work.

[lukasmatena]

Duplicate of #569. I already have a partial prototype, but there is a lot of work yet to be done. Hopefully we'll get it into PrusaSlicer 2.5.