QGIS3: no precision in identify (derived data)

[qgib]

Author Name: Tobias Wendorff (Tobias Wendorff)
Original Redmine Issue: 18602
Affected QGIS version: 3.0.0
Redmine category:gui

---

In identify results, the derived data (like X/Y coordinates of points) are integer only.

Same behavior in 6ddd9ab and below.

[qgib]

Author Name: Tobias Wendorff (Tobias Wendorff)

---

Addition information: I'm expecting the value to be float. Tested on non-geographical projections like EPSG:25832 and EPSG:3857

[qgib]

Author Name: Nyall Dawson (@nyalldawson)

---

Check Project Properties -> General -> Coordinate Display -> Precision. It's probably set too low.

---

• resolution was changed from to invalid
• status_id was changed from Open to Closed

[qgib]

Author Name: Tobias Wendorff (Tobias Wendorff)

---

Yep, that's it. It was set to "automatic". Perhaps automatic should be 2/3 on projected coordinate systems by default?! Integer (zero precision) is a little bit too low as a default value.