You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I'm trying to use ReaR 2.0 to recover a RHEL7 host that boots from a SAN disk and uses EMC powerpath for the multipathing software. I've been going around and around trying to get it to work with no luck but then again I am new to ReaR. Before adding configuration files, I'd like to know if using EMC Powerpath is something that has already been looked at and deemed not possible.
Thanks, Tom
The text was updated successfully, but these errors were encountered:
I'm trying to use ReaR 2.0 to recover a RHEL7 host that boots from a SAN disk and uses EMC powerpath for the multipathing software. I've been going around and around trying to get it to work with no luck but then again I am new to ReaR. Before adding configuration files, I'd like to know if using EMC Powerpath is something that has already been looked at and deemed not possible.
Thanks, Tom
The text was updated successfully, but these errors were encountered: