FAN 2 pin

[BeerMoneyMotorsports]

Fan 2 pin should allow me to select pin 1I but it is not present in the drop down. This should also be the default setting.

• pin: 1I
  id: GPIOA_9
  class: outputs
  ts_name: 1I AC Fan Relay
  function: AC Fan Relay

[rusefillc]

fan2Pin = bits, U08, 2713, [0:7], "NONE","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","3V - O2H2","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","3D - MAP","INVALID","INVALID","INVALID","INVALID","ETB +","ETB +","ETB +","INVALID","INVALID","INVALID","INVALID","3G - IGN_1 (1&4)","INVALID","INVALID","INVALID","INVALID","INVALID","1U - O2H","INVALID","INVALID","INVALID","INVALID","INVALID","4E - VVT","3Z - INJ_4","3Y - INJ_3","1R - ECF","2K - TACH","2Q - IDLE","1O - ALTERN","INVALID","INVALID","INVALID","INVALID","INVALID","3H - IGN_2 (2&3)","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","INVALID","3T/4D - BOOST OUT","INVALID","3Q - VICS","INVALID","INVALID","INVALID","2M US / 2P EUROPE - FPUMP","INVALID","1E - Check Engine Light","INVALID","INVALID","3W - INJ_1","3X - INJ_2","INVALID","INVALID","1S - AC Relay","1Q - Aternator Warning Lamp", 

[rusefillc]

@BeerMoneyMotorsports please clarify how should GPIOA_9 be used - AC Fan Relay or Rear O2 sensor heater?

  - pin: 3V
    id: GPIOA_9
    class: outputs
    ts_name: 3V - O2H2
    function: Rear O2 sensor heater
    type: ls

[BeerMoneyMotorsports]

3v was wrong and i have fixed it.

[rusefillc]

I've added default value please validate

[BeerMoneyMotorsports]

validated. thank you.