-
Notifications
You must be signed in to change notification settings - Fork 19
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
GM fuel pressure decoding #146
Comments
progress under #148 10 bar looks great
no pressure - probably should it be close to 1 @dron0gus ? what does it show on your end?
|
No pressure. Saint-P. Almost sea level.
|
How high does this sensor go? If it's a GDI sensor, I'd expect at least 200 bar, so 0.05 bar resolution isn't terrible. 200/0.05 is 12 bits. |
Actual resolution seems 1/10 Atm rusefi-hardware/SENT-box/firmware/sent.cpp Line 458 in fc7550c
But we can get 0.05 by averaging two signals. |
Hi, |
@floods57 all the code is at https://github.com/rusefi/rusefi-hardware/tree/main/SENT-box/firmware |
@floods57 can you share partnumber(s) of these sensors? |
Thanks a lot ;) |
@floods57 thanks for partnumbers. |
Ok, but i am not sure about the code i must use, i looking for the same as in this video : https://www.youtube.com/watch?v=S2xH2oOEYL8 i looking to do a similar testing with a Blue Pill to 1st find the value of the sensor. |
@floods57 for bluepill use https://github.com/rusefi/rusefi-hardware/tree/main/SENT-box/firmware code. But check main RusEFI FW for possible updates, changes. |
04E906051H
|
Pinout: |
Ok, Thanks i will try it ;) |
Ok, so many chance that the 04E906051J use the same pinout, will try it, look really difficult to get any information for this sensor. |
@dron0gus By the way, did you use a RC filter ? Thanks |
@floods57 do you mean input RC filter? No, I'm debuging on MRE board and using analog input with filter C removed. So signal path is OpAmp with K = 1 -> 1/2 divider -> STM32 pin. |
ambient room
10 bar = 1000 KPa
The text was updated successfully, but these errors were encountered: