You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
When using support inside an object (lower end of the support is touching a surface of the object), the distance between object and support seems to be the normal support layer height. This leads into sticky support.
I would expect to have it configurable manually like the "support contact z-distance" for the top interface or at least reuse this variable.
When I looked at the SupportMaterial.pm I assume, there is currently no explicit handling of the bottom distance and it's handled by the object clipping routine.
The text was updated successfully, but these errors were encountered:
Version
1.2.9-276-g8a72ffb
Operating system type + version
Any
Behavior
When using support inside an object (lower end of the support is touching a surface of the object), the distance between object and support seems to be the normal support layer height. This leads into sticky support.
I would expect to have it configurable manually like the "support contact z-distance" for the top interface or at least reuse this variable.
When I looked at the SupportMaterial.pm I assume, there is currently no explicit handling of the bottom distance and it's handled by the object clipping routine.
The text was updated successfully, but these errors were encountered: