-
Notifications
You must be signed in to change notification settings - Fork 92
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
No output after 'Init CC1100...' (Arduino) #56
Comments
Hi @DrahcPro , thx |
The specific issue is not the case anymore (probs user error), I still have other issues which I am trying to figure out though. Namely tx side example is working but rx side is not receiving. I'll be trying some stuff out today and tomorrow and will post a new issue if I can't figure it out. |
well, unfortunatly I have no hardware for this project anymore and I can not give good support, but as I remenber right I used a M16 AVR. In the beginning I had some trouble with the Interrupt routine and I would suggest that you check the GPIO2 of the RF board board if ther is a HIGH level signal after sending the package with the TX Demo. If the state changes from LOW to HIGH, than you should check the Pinning again and check if the Interrupt triggers on the right GPIO of the Arduino board. |
Alright, I'll check that first 👍 |
Ow and now I have your attention, could you maybe add a note in the readme that the pinout for arduino MEGA is not the same as UNO this caused a fair bit of confusion for me as well (SPI are on the UNO in the 10s and in the MEGA on the 50s) |
I have installed the package and library, followed the instructions to install the script onto an arduino but it only prints "Init CC1100..." and nothing else. I've already jumped into the code at it must be going wrong somewhere between line 374 and 405 because after that there should be an output. Any tips on how to debug this further?
I am using an arduino mega 2560 together with an E07-M1101D-SMA chip.
The text was updated successfully, but these errors were encountered: