-
Notifications
You must be signed in to change notification settings - Fork 18
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
run blower fan for circulation #194
Comments
With the latest release, you should be able to keep the fan on with the cooler. For that, you need to define a fan and set the: heater: switch.climate_control_heater
cooler: switch.climate_control_ac
fan: switch.climate_control_fan
fan_on_with_ac: true You don't need to set ac_mode |
I am a bit confused, I don't have issues keeping the fan on with the cooler, I want to be able to circulate the air with just the fan when the ac/heater is not on. For example, check if ac/heater has run in the last 20 minutes, if not, turn on blower fan for 5 minutes and reset 20 minute timer, then do again. If the ac or heater kicks on, then reset timer. |
OK. You will still need to configure the fan property. After that, you can turn on the fan mode with automation. (hvac_mode->fan_only) |
SO I have tried to write a couple automations a few different ways and I am noticing that after setting the dual smart thermostat to fan only and turning on the fan that it cuts off prematurely. I tried for a 3 min every 20 minutes and now i am trying a 12 min every hour. This last test, the fan cut off after 2-3 minutes. Config
automation
Other automation, the one I prefer to use
|
You can also try to set a lower target temperature in your automation, as the fan works like a cooler. |
Closing this due to inactivity |
Curious if I am not reading something right, or if this would be an enhancement. I have an hvac system with 3 relays, each relay for heating, cooling and blower fan. My hvac board logic knows to cut the blower fan if the heat is on (gas) but for the cooling, i have to manually turn on the blower fan. Also I want to be able to circulate air a few times an hour if the climate does not call for turning the heating/cooling on.
Below is my config
Any help would be greatly appreciated
The text was updated successfully, but these errors were encountered: