You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Everything works, but I did discover a couple of problems which were totally my fault: I routed the traces for the RS485 module backwards. Also, the two headers of pins for the the grand central are out of alignment with each other by roughly .5-1mm. Lastly, there are two sets of holes for pins at the bottom of the RS485 module. This was to provide soldering points for the wires going to the AMP connector in line with the pins on the RS485 module. I connected the outer four respectively, but did not put traces on the inner four.
The text was updated successfully, but these errors were encountered:
Everything works, but I did discover a couple of problems which were totally my fault: I routed the traces for the RS485 module backwards. Also, the two headers of pins for the the grand central are out of alignment with each other by roughly .5-1mm. Lastly, there are two sets of holes for pins at the bottom of the RS485 module. This was to provide soldering points for the wires going to the AMP connector in line with the pins on the RS485 module. I connected the outer four respectively, but did not put traces on the inner four.
The text was updated successfully, but these errors were encountered: