Click on the button below:
Or, in your Home Assistant, navigate to Configuration > Add-ons, Backups & Supervisor > Add-on Store > ... > Repositories and add https://github.com/tube0013/tubeszb_addons
to the list.
Video Walk Through: https://www.youtube.com/watch?v=W28hdRx0mV4
- Navigate in your Home Assistant frontend to Settings -> Add-ons, Backup & Supervisor -> Add-on Store.
- Find the "TubesZB TI CC2652 FW Flasher" add-on and click it.
- Click on the "INSTALL" button.
The add-on needs a TI CC2652 wireless module accessible through a network serial port (defined by IP address and port) or other USB-based wireless adapters.
- In the add-on configuration enter the IP_ADDRESS:port in the Network Device entry form
- Select any serial device to make the form happy
- Select to enable the ESPHome trigger of the bootloader for network coordinators. (note may not work with all TubesZB ESPHome firmware versions versions, If not open the coordinator's web frontend in a browser and trigger the BSL/Bootloader mode there)
- Enter in the url for the Z-Stack Firmware - be sure to use the raw GitHub link example: https://github.com/Koenkk/Z-Stack-firmware/raw/7398d834eb3a790876c280293c4181da96cc7114/coordinator/Z-Stack_3.x.0/bin/CC1352P2_CC2652P_launchpad_coordinator_20221226.zip
- Start the add-on.
- Monitor the flash by going to the addon log page and refreshing periodically.
- In the add-on configuration enter some text into the Network Device entry form to make the form happy
- Select the correct serial device from the list of devices detect, Toggle the switch to enable USB Flash (Coordinator must be in bootloader mode before addon is started, hold BSL button while plugging into USB)
- Enter in the url for the Z-Stack Firmware - be sure to use the raw GitHub link example: https://github.com/Koenkk/Z-Stack-firmware/raw/7398d834eb3a790876c280293c4181da96cc7114/coordinator/Z-Stack_3.x.0/bin/CC1352P2_CC2652P_launchpad_coordinator_20221226.zip
- Start the add-on.
- Monitor the flash by going to the addon log page, and refreshing periodically.
Add-on configuration:
Configuration | Description |
---|---|
device | Serial service where the Silicon Labs radio is attached |
network_device | Network Serial port (IP_ADDRESS:PORT) |
flow_control | If hardware flow control should be enabled (depends on firmware) |
firmware_url (mandatory) | Custom URL to flash firmware from |
Got questions?