This is a Python library and accompanying CLI utility for reading sensor values from Hanazeder FP heating pumps.
Based on the work done by Thomas Binders serial_hlc20 (https://github.com/binderth/serial_hlc20) and Benedikt Merz research in his blog at (https://benedikt-merz.de/Blog/?p=157) - both very much appreciated!
With this connection, you could change all the values of your Hanazeder controller, which could result to a non-functional heating! Be careful, what parameter you're about to write. If you're only using read, you're safe! I don't take responsibilities for any damage or mis-interpretation caused by the python script. Use it at your own risk!
This python script opens a serial connection to the hanazeder FP10 home automation controller (http://hanazeder.at/page/building-automation) and reads out the values of the programmed modules (e.g. temperature sensors, valve statusses, ...).
- hanazeder FP system (so far only tested with FP10)
- serial connection (either direct or via USB<>RS232 controller) or TCP/IP via a remote RS232 (ser2net, ...)
Currently the script only reads registers
This is the number of the parameter or the port of the module (starting with 0)
- install usbutils
sudo apt-get install usbutils(if you're going to use the USB<>RS232 controller) - install python dependencies
pipenv install - add your script user to the
tty-groupsudo addgroup pi tty
Read from a serial to TCP converter (like ser2net) at 192.168.1.2 port 2001 the register 1:
python -m hanazeder.read --address 192.168.1.2 --port 2001 --register 1