The NeoHub binding allows you to connect openhab via TCP/IP to Heatmiser's NeoHub and integrate your NeoStat thermostats onto the bus.
This binding can be configured in the file services/neohub.cfg.
The binding polls each thermostat that is configured in your items, at the refresh rate as set in the configuration.
| Property | Default | Required | Description |
|---|---|---|---|
| refresh | 60000 | No | Refresh interval in milliseconds |
| hostname | Yes | the NeoHub network address | |
| port | 4242 | No | the port number for the NeoHub interface |
Item strings simply consist of two components - the NeoStat device name (as set in the thermostat and in the mobile app, e.g. Office), and the NeoStat property (e.g. CurrentTemperature). Both parameters are only separated by a colon. Some examples are below.
Switch Heating_Office "Heating Office" {neohub="Office:Heating"}
Switch Away_Office "Away Office" {neohub="Office:Away"}
Switch Standby_Office "Standby Office" {neohub="Office:Standby"}
Number Temperature_Office "Temperature [%.1f °C]" {neohub="Office:CurrentTemperature"}
The following properties, and their associated item types are shown below. The R and RW in the description column indicate which properties are read only (RO) or read/write (RW).
| Property | Type Supported | Description |
|---|---|---|
| CurrentTemperature | Number | RO Current room temperature |
| CurrentSetTemperature | Number | RO Current set temperature |
| CurrentFloorTemperature | Number | RO Current floor temperature |
| DeviceName | String | RO Returns the device name |
| Heating | Switch, String | RO Returns ON or OFF if heating is currently enabled or not |
| Away | Switch, String | RW Returns ON or OFF if thermostat is in away mode or not |
| Standby | Switch, String | RW Returns ON or OFF if thermostat is in standby mode or not |