You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Description:
Seems that after the conversion the no copper zones are not taken into consideration and I get a full copper fill for the board. This happens for both sides of the board. See attached pictures and the original project file.
Expected result:
No copper zones should be respected after conversion.
Small note:
The "no copper" zones are stacked over the "full copper" zones creating the subtraction effect in the original design.
Description:
Seems that after the conversion the no copper zones are not taken into consideration and I get a full copper fill for the board. This happens for both sides of the board. See attached pictures and the original project file.
Expected result:
No copper zones should be respected after conversion.
Small note:
Conversion:
Original:
EasyEDA project:
Touch_Switch_2ch.zip
easyeda2kicad version: 1.3.1
The text was updated successfully, but these errors were encountered: