Hanson rPI-MFC Upload Output Channel Number Error

[TripleJ3EB]

Windows 2022.24
Hanson Electronics
rPi-MFC
Auto Layout
Auto Size
DDP
Keep Channel Numbers NOT Checked

When you upload the output, it sets the channel numbers to the xLights Channel Number, it does not start at 1 as it should observe with the Keep Channel Numbers not checked. The LED Panel should start at Channel 1, and the Pixels should start right after the LED Panel Count.

[dkulp]

That checkbox should not available for FPP controllers. FPP controllers should be matching the xLights channel numbers.

[TripleJ3EB]

If I manually set the channel numbers in FPP as 1 for the Panel, and Pixels to 12289 in my case (2 P5 panels for the Boscoyo Wired Watts Bulbs), playing from xLights and xScheduler works fine. I always have DDP start at channel 1 as it doesnt require rerendering and reuploading output every single little change I make on a different controller.

[cybercop23]

You can move this controller to the top of the list to ensure it aleays starts at 1. Either that, or check the Hat (last check box) in FPP Conect to push the latest config.

Please review and close this issue if that meets your needs.