Replies: 9 comments 11 replies
-
Well asking that after you already installed the new version is a bit too late :D! Unless they are actively trying to brick your device. Still, do not upgrade your printer if it has not been validated first, or unless you fully understand the potential consequences. |
Beta Was this translation helpful? Give feedback.
-
If you read my message, I have more than one machine. I guess I'm just testing out the new firmware with .04. It does power up fine and will find out more today. I can also still run the macro to restart in regular mode, phew. I'm also telling others that it does NOT brick your printer if you upgrade, just asking what might be broken though. |
Beta Was this translation helpful? Give feedback.
-
I rebooted into the stock firmware and updated. Totally forgot it was unknown whether or not this would cause issues! I tested the new Orca-Flashforge with it and of course came running back to Mainsail. Everything seems fine though, print in progress right now with no issues. |
Beta Was this translation helpful? Give feedback.
-
My understanding is that 2.6.5 has been pulled . FF are now issuing 2.6.4 |
Beta Was this translation helpful? Give feedback.
-
Just did the ota update, it only changes the It will have no impact on the klipper-mod. |
Beta Was this translation helpful? Give feedback.
-
i was unable to install mod running 2.6.5
|
Beta Was this translation helpful? Give feedback.
-
Factory reset did NOT remove 2.6.5 for me. YMMV |
Beta Was this translation helpful? Give feedback.
-
I upgraded to 2.6.6, my Pro seemed to upgrade and rebooted fine, but my A5M upgraded rebooted and froze. Another reboot and it started up fine. |
Beta Was this translation helpful? Give feedback.
-
Updated my printer to 2.6.6 as well, no issues with the mod. I think we can make 2.4.5 the minimum version and allow installation and all versions after that. Since we can't or don't want to prevent OTAs from Flashforge, I guess there is not much point to prevent installation on newer versions. |
Beta Was this translation helpful? Give feedback.
-
Are there any issues upgrading firmware to 2.6.5? One of my machines I restarted with regular firmware and got the upgrade message so I allowed it to update. I then rebooted it and Klipper screen started again. Seems fine, just want to be sure. Thanks
Beta Was this translation helpful? Give feedback.
All reactions