You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
From datasheet, I only figured out if I want to set a pin (e.g P17) to output LOW, I can use I2C to write 3 bytes as the following:
0100 A2A1A00
0xxx xxxx
xxxx xxxx
Is it correct? But I cannot figure out how to set P17 to output mode.
The text was updated successfully, but these errors were encountered:
Hi,
From datasheet, I only figured out if I want to set a pin (e.g P17) to output LOW, I can use I2C to write 3 bytes as the following:
0100 A2A1A00
0xxx xxxx
xxxx xxxx
Is it correct? But I cannot figure out how to set P17 to output mode.
The text was updated successfully, but these errors were encountered: