-
-
Notifications
You must be signed in to change notification settings - Fork 252
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Qnap Qhora 301-W #3194
Comments
You can follow https://openwrt.org/toh/qnap/301w (with detailed instructions openwrt/openwrt@bd17683) then you can update to OpenMPTCProuter |
What is the result of |
ok, no network config. |
Can you do: |
Yes it worked :) Thank you very much. Do I need to install the 10G Aquantia FW for 10G ports? Do you think this device is powerful enough to allow me to combine 2x 1.000/100 connections and use them as 2.000/200? |
If I didn't forget something, it should already have aquantia fw. |
It's because they are not configured, you need to set all interfaces correctly in Network->Interfaces |
I still cannot use the 10G ports even though I have configured them in the interface section. Even the LEDs of the ports are not lit. Maybe something to do with the link speed settings?
|
For WAN port, in Network->Interfaces you need to set another port than "lan" for WAN port. |
You removed 10g interfaces configuration ? Doesn't help to check if it's correct. |
VPS API answer, check that you use correct API key. |
I realize that I might have been putting you through some inconvenience, but I've been trying to set this up and get it to work properly for 2 months, so I really don't want to give up. I hope you can understand. Before purchasing the Qnap 301-w, I successfully ran a setup using Debian 11 and a virtual machine with kernel 5.4 on the VPS side, and a virtual machine inside a router without any issues. In other words, I have previously managed to install and configure everything smoothly. However, due to inadequate hardware performance, I opted for the Qnap 301. My initial setup was quite straightforward; I only had to enter the Server Key and VPS IP address. This time, I can't seem to figure out the problem. I didn't enter the API Admin Key, and I can't seem to find this option in the interface. When I enter the other details manually, it only works as Shadowsocks. I can't connect through V2ray or any other proxy. You're the only support I can turn to. It would mean a lot to me if you could find some time to assist me again. Thank you so much in advance. |
The API Admin key is only used for API configuration, not needed in your case. |
This issue is stale because it has been open 90 days with no activity. Remove stale label or comment or this will be closed in 5 days |
Current Behavior
I can't install the bin. file I downloaded from Snapshots on Qhora 301-W.
Is there any guide on how to install it on this device?
Specifications
The text was updated successfully, but these errors were encountered: