Skip to content

Latest commit

 

History

History
74 lines (51 loc) · 2.24 KB

pynq_z2_setup.rst

File metadata and controls

74 lines (51 loc) · 2.24 KB
Raw

PYNQ-Z2 Setup Guide

Prerequisites

  • PYNQ-Z2 board
  • Computer with compatible browser (Supported Browsers)
  • Ethernet cable
  • Micro USB cable
  • Micro-SD card with preloaded image, or blank card (Minimum 8GB recommended)

Getting Started Video

You can watch the getting started video guide, or follow the instructions in :ref:`pynqz2-board-setup`.



Board Setup

../images/pynqz2_setup.png
  1. Set the ** Boot** jumper to the SD position. (This sets the board to boot from the Micro-SD card)
  2. To power the board from the micro USB cable, set the Power jumper to the USB position. (You can also power the board from an external 12V power regulator by setting the jumper to REG.)
  3. Insert the Micro SD card loaded with the PYNQ-Z2 image into the Micro SD card slot underneath the board
  4. Connect the USB cable to your PC/Laptop, and to the PROG - UART MicroUSB port on the board
  5. Connect the Ethernet port by following the instructions below
  6. Turn on the PYNQ-Z2 and check the boot sequence by following the instructions below

Turning On the PYNQ-Z2

As indicated in step 6 of :ref:`pynqz2-board-setup`, slide the power switch to the ON position to turn on the board. The Red LED will come on immediately to confirm that the board has power. After a few seconds, the Yellow/Green / Done LED will light up to show that the Zynq® device is operational.

After a minute you should see two Blue ** LEDs and four **Yellow/Green LEDs flash simultaneously. The Blue LEDs will then turn on and off while the Yellow/Green LEDs remain on. The system is now booted and ready for use.