You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
This switch is detected by ZHA without a custom quirk, but is missing some core settings functionality that is supported using the clipsal/Schneider zigbee hub.
as described here the switch has a configurable backlit LED behind the button which can operate in one of four modes: Reverse with load, Consistent with load, Always on and Always off.
Additionally, there are also minimum and maximum ballast settings which allow configuration of the minimum and maximum brightness controls, which helps to configure for different lights that have different dimmer responses.
Solution description
Add UI controls for "LED indicator mode", "ballast minimum" and "ballast maximum".
The LED Indicator solution should also apply for the related device 41E2PBSWMZ. This is the non-dimming wiser switch without ballast options. I do not have one of these non-dimmer units to test on.
My interpretation of the above is that the cluster "0xff17" as seen in the scan results is related to the LED indicator mode (code snippet below). The ZHA UI for this cluster does not show any attributes or commands.
I am more than happy to spend time testing and debugging but I must stress that I have next to no experience with ZHA and am totally lost when it comes to json, quirks, etc.
The text was updated successfully, but these errors were encountered:
alexeiw123
changed the title
[Device Support Request]
[Device Support Request] Clipsal/Schneider 41EPBDWCLMZ additional features missing
Dec 10, 2023
alexeiw123
changed the title
[Device Support Request] Clipsal/Schneider 41EPBDWCLMZ additional features missing
[Device Support Request] Clipsal/Schneider Wiser 41EPBDWCLMZ additional features missing
Dec 10, 2023
Problem description
This switch is detected by ZHA without a custom quirk, but is missing some core settings functionality that is supported using the clipsal/Schneider zigbee hub.
as described here the switch has a configurable backlit LED behind the button which can operate in one of four modes: Reverse with load, Consistent with load, Always on and Always off.
Additionally, there are also minimum and maximum ballast settings which allow configuration of the minimum and maximum brightness controls, which helps to configure for different lights that have different dimmer responses.
Solution description
Add UI controls for "LED indicator mode", "ballast minimum" and "ballast maximum".
The LED Indicator solution should also apply for the related device 41E2PBSWMZ. This is the non-dimming wiser switch without ballast options. I do not have one of these non-dimmer units to test on.
Screenshots/Video
No response
Device signature
Device signature
Diagnostic information
No response
Logs
No response
Custom quirk
No response
Additional information
ZHA Toolbox Scan
Z2MQTT support of these features
Github discussion on adding support to Z2MQTT
My interpretation of the above is that the cluster "0xff17" as seen in the scan results is related to the LED indicator mode (code snippet below). The ZHA UI for this cluster does not show any attributes or commands.
I am more than happy to spend time testing and debugging but I must stress that I have next to no experience with ZHA and am totally lost when it comes to json, quirks, etc.
The text was updated successfully, but these errors were encountered: