This is an update to EnergyCam setup for Raspberry Pi, created by FF
Checklist
[ ] debug problem with mW dongle [ ] check if this is not due to key number conversion
Hardware needed to run this:
-
Raspberry Pi
-
FAST EnergyCam RF and FAST USB Communication Interface to configure the Energycam prior to installation (available at http://umwelt-messtechnik.de/index.php?cat=c91_Smart-Grid-Komponenten-Smart-Grid-Komponenten.html)
-
wireless M-Bus USB Stick (2 manufacturers are supported)
- IMST IM871A-USB Stick ( available at http://www.tekmodul.de/index.php?id=shop-wireless_m-bus_oms_module or http://webshop.imst.de/funkmodule/im871a-usb-wireless-mbus-usb-adapter-868-mhz.html)
- AMBER Wireless M-Bus USB Adapter (http://amber-wireless.de/406-1-AMB8465-M.html)
-
EDIMAX EW-7811UN Wireless USB Adapter
Software:
- dygraph (https://github.com/danvk/dygraphs)
Features:
- The application shows you all received wireless M-Bus packages.
- You can add meters that are watched. The received values of these are written into csv files and presented on the webserver.
- The energy usage is shown as an interactive, zoomable chart of time on a website.
- install.txt describes how to configure the raspberry and compile the sources
Trademarks
Raspberry Pi and the Raspberry Pi logo are registered trademarks of the Raspberry Pi Foundation (http://www.raspberrypi.org/)