PIC18F47Q10 Changing Data Transfer Type

Objective

This repository contains an example of Foundation Services generated source code for SPI as described in TB3265 - Getting Started with SPI using MSSP on PIC18 document from Microchip.
In this demo, the SPI will be configured as host and it will be used to send data to a client device, in data mode 3.

Related Documentation

• TB3265 - Getting Started with SPI using MSSP on PIC18
• PIC18-Q10 Product Family Page
• PIC18F47Q10 Data Sheet
• PIC18F47Q10 Code Examples on GitHub

Software Used

• MPLAB® X IDE 5.30 or newer (microchip.com/mplab/mplab-x-ide)
• MPLAB® XC8 2.10 or a newer compiler (microchip.com/mplab/compilers)
• MPLAB® Code Configurator (MCC) 3.95.0 or newer (microchip.com/mplab/mplab-code-configurator)
• MPLAB® Code Configurator (MCC) Device Libraries PIC10 / PIC12 / PIC16 / PIC18 MCUs 1.79.0 or newer (microchip.com/mplab/mplab-code-configurator)
• MPLAB® Code Configurator (MCC) Foundation Services Library (microchip.com/mplab/mplab-code-configurator)
• Microchip PIC18F-Q Series Device Support 1.3.89 or newer (packs.download.microchip.com/)

Hardware Used

• PIC18F47Q10 Curiosity Nano (DM182029)

Setup

The PIC18F47Q10 Curiosity Nano Development Board is used as the test platform.

The following configurations must be made for this project:

• Clock

  • Oscillator Select: HFINTOSC
  • HF Internal Clock: 64 MHz
  • Clock Divider: 1

• MSSP1:

  • MSSP1 Enabled
  • Serial Protocol: SPI
  • Mode: Master
  • Data Mode: 3
  • Input Data Sampled At: Middle
  • Clock Source Selection: FOSC/4_SSPxADD
  • SPI Clock Frequency: 8 MHz

• Watchdog Timer: disabled

• Low-voltage Programming: enabled

Pin	Configuration
RC3 (SCK)	Digital Output
RC4 (SDI)	Digital Input
RC5 (SDO)	Digital Output
RC6 (SS)	Digital Output

Operation

1. Connect the board to the PC.

2. Open the pic18f47q10-cnano-spi-mode-change-fs.X project in MPLAB® X IDE.

3. Set pic18f47q10-cnano-spi-mode-change-fs.X project as main project. Right click on the project in the Projects tab and click Set as Main Project.

4. Select the PIC18F47Q10 Curiosity Nano in the Hardware Tool section of the project settings:

• Right click on the project and click Properties;
• Select the PIC18F47Q10 Curiosity Nano (click on the SN) in the Hardware Tool tab and then click OK:
  

5. Program the project to the board: right click on the project and click Make and Program Device.

Result:

• Channel 0 -> SCK
• Channel 1 -> SDI
• Channel 2 -> SDO
• Channel 3 -> SS
  

Summary

This project is an illustration for a basic use case based around MSSP1 in SPI mode.