This enclosure is designed to be sleek and minimalistic. It is designed to be 3D printed. This case does not provide any camera or display port access. But GPIO are easily accessibles.
This enclosure support following boards:
- Raspberry PI 1B+
- Raspberry PI 2B
- Raspberry PI 2B 1.2
- Raspberry PI 3B
- Raspberry PI 3B+
Two versions of the upper part are available. One with GPIO access and one without. Ideal for a clean look or server applications like VPN, DNS...
RPI_3bplus_enclosure_lower_1.2.STLLower part of the enclosure common to allRPI_3bplus_enclosure_upper_1.2.STLOrginal upper part of the enclosure with GPIO accessRPI_3bplus_enclosure_upper_1.2_no_gpio.STLUpper part of the enclosure without GPIO accessgpio_cover.STLCover for GPIO. Best of both worlds, clean look and easy access to GPIO
This enclosure is designed to be used with passive cooling solution. 35x35x12mm heatsink is recommended.
A 1mm copper plate between the CPU and the heatsink is needed to allow space for surrounding components.
No need for fan event with intense CPU usage.
Clearance is 0.2mm for all parts to facilitate assembly. No support is needed.
4x M3x24mm flat-head screws and 4x M3 nuts are needed to assemble the case.
1mm hole above jack connector is designed to fit a 6x6mm push button. This button can be used to wake the Raspberry PI.
Version 1.0 without clearance for SD card removal
Printing settings:
- 3D printer: Zortrax M200+
- Material: Z-PLA Pro
- Nozzle diameter: 0.4mm
- High quality
- Layer height: 0.09mm
- Infill: 20%
- No support
Run button hole above jack connector
Little issue with the GPIO border, was to tight. fixed.
Kapton tape is used to isolate heatsink from the board.
