DifferentExample #12
Replies: 1 comment 1 reply
-
No problem, use whatever you need! I think there'll be more than a few modifications, but not too difficult. You'll need to install their library then I'd probably start by getting their example to work. I took a quick look, note that it defaults to software SPI and the PT100 RTD sensor. You may need to change to RNOMINAL to 1000.0 if you have the PT1000 sensor. I would suggest verifying that everything works with software SPI first, then test the hardware SPI settings and pin configuration that matches or closely matches what is used with the MAX31856. I've used the drdyPin on the 31856 to speed up reads (they describe this on page 6 here). On the PCB its labelled DRDY. Looks like this same feature is also available on your max31865 where the breakout pin is labelled RDY. It would be interesting to hear how this works out with your setup. |
Beta Was this translation helpful? Give feedback.
-
I want to check out your library and have a slightly different environment:
I have an Adafruit_MAX31865 instead of Max31856, I assume I can just pass this controller in, I will look closer.
I have a relay with two pins, one on and one off.
I'm not sure what the drdyPin is, I will sort that out next;
Do you have a problem if I copy the example and make it work with these two modifications? I will be able to tell you the changes I made or just give you the result after I have it worked out.
Beta Was this translation helpful? Give feedback.
All reactions