You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Tried to using Tony today and wasted 2 sheets of material as theres barely any output, altered settings no luck!
Wont cut through 3mm mdf just leaving line drawings.
Also went onto use Gerarld a fire started (small fire) and then went onto realise the plastic piple, exhasut pipe that filters the smoke is split in to two oviously causing the fire.
Thanks Jade
The text was updated successfully, but these errors were encountered:
Tried to using Tony today and wasted 2 sheets of material as theres barely any output, altered settings no luck!
Wont cut through 3mm mdf just leaving line drawings.
Also went onto use Gerarld a fire started (small fire) and then went onto realise the plastic piple, exhasut pipe that filters the smoke is split in to two oviously causing the fire.
Thanks Jade
The text was updated successfully, but these errors were encountered: