You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I hope this is possible on my Panasonic heat pump: :)
Is it possible to trigger the backup heater directly using the optional PCB or the CN-CNT port.
Thanks in advance.
Best regards
Peter
The text was updated successfully, but these errors were encountered:
________________________________
From: geduxas ***@***.***>
Sent: Monday, June 10, 2024 9:46:43 PM
To: Egyras/HeishaMon ***@***.***>
Cc: Peter R. Lauridsen ***@***.***>; Author ***@***.***>
Subject: Re: [Egyras/HeishaMon] How to trigger backup heater using optional PCB or RS485 protocol (Issue #495)
No, it's backup, it's used by panasonic logic for backup operations.. not main..
—
Reply to this email directly, view it on GitHub<#495 (comment)>, or unsubscribe<https://github.com/notifications/unsubscribe-auth/BDQ2SQJKN2LHCHRHS2XEFATZGX7CHAVCNFSM6AAAAABJC4MNOGVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDCNJZGE3DCNJRGM>.
You are receiving this because you authored the thread.Message ID: ***@***.***>
Hi all
I hope this is possible on my Panasonic heat pump: :)
Is it possible to trigger the backup heater directly using the optional PCB or the CN-CNT port.
Thanks in advance.
Best regards
Peter
The text was updated successfully, but these errors were encountered: