-
Hi there, I was looking to enable my firewall on our linux stations with a simple config file and supporting zone (because I saw the zone concept in KDE interface config). Now I have a special case. For "admin" zone, I've got two setup. Either I use a specific VPN (so I configure it with "admin" zone in kde gui) or in local mode, I run a script that setup admin interface (vlan50 and different ip mask ) as is: sudo ip link add link eth0 name eno1.50 type vlan id 50 My currrent issue, is how could I say to foomuuri that eno1.50 must be set as "admin zone"? I got currently this in my config: Should I set: In this case will it work with vpn setup? (that can be bind to tun0 or tun1 depending how many vpn I setup) Thanks for your help! |
Beta Was this translation helpful? Give feedback.
Replies: 2 comments 1 reply
-
Hello, |
Beta Was this translation helpful? Give feedback.
-
Hi, Thanks. It's always nice to hear that others find Foomuuri useful too. As you already tested, your above assumptions were correct. Simply use:
It defines default interfaces for zone Apparently KDE's connection manager looks quite similar to |
Beta Was this translation helpful? Give feedback.
Hello,
I just did a test today, and specifying "admin eno1.50" in the zone {} parameter apply the admin zone to my manually created interface, and I can also specify zone in kde gui interface.
Don't know if normal , but looks like "admin eno1.50" is not an exclusive parameter.
So everything is good.